2006 Ford Mustang
Mileage
107,009
Service Date
9/16/2022
Services Performed
- Scanned ecu and retrieved codes P0161 02 sensor heater circuit bank 2 sensor 2, P0622 generator field control problem P2272 sensor signal stuck lean B2103 passive anti theft system B2940 chime output circuit short to ground B1342 faulty control module B1676 battery voltage out of range B2035 left front repeater lamp output circuit fail B2276 less than 2 transmitters programmed B2519 high mount stop lamp circuit fault B1084 trunk lamp circuit fault B1318 low battery voltage at module Bank 2 sensor 2 is steady at 0.0 volts. Swapped rear oxygen sensor bank to bank-both rear oxygen sensors are operating normally now. Checked for damage at connectors-none found. Test drove vehicle-P0161 heater circuit code for B2S2 is pending. Suspect PCM fault, power, ground, and heater resistance ok. System voltage is 14.1 to 14.5 volts when running, suspect this is an old code.
- Changed engine oil and filter. Checked and replenished all fluids. Checked and adjusted tire air pressure.
- Vents don't move from defrost to face? Has slight brake pulsation Wipers work lights work Serp belt good condition Coolant full Air filter clean Brake fluid full clean Tires are almost new Front brakes 80 Rear brakes 70 Rear shocks leaking Rear diff seeping U joints good Valve covers seeping Trans line seeping Possible Rear main Front crank seal seeping Front radiator and condenser have been hit and bent in wards, not leaking Front Struts good Both control arm bushings torn
- Replaced both left and right lower control arms and ball joint assemblies. Test drove vehicle.
Dorothy D. gave our service a 5 star review on 9/16/2022
